521 research outputs found

    Design and performance of a multichannel multisampling analog to digital converter board for energy measurement

    Get PDF
    Abstract This paper describes a VME multichannel multisampling ADC board designed for low-energy physics experiments. To guarantee the maximum experimental flexibility the module is completely programmable through a digital signal processor and a program register accessible via VME bus. With a frequency of 40 MHz, the single channel can acquire a variable number of samples of each analog input. Besides, it is possible to use the board as a 160 MHz waveform digitizer, grouping four channels together and feeding the same analog inputs via an external fan-out

    Design of a Base-Board for arrays of closely-packed Multi-Anode Photo-Multipliers

    Full text link
    We describe the design of a Base-Board to house Multi-Anode Photo-Multipliers for use in large-area arrays of light sensors. The goals, the design, the results of tests on the prototypes and future developments are presented.Comment: 16 pages, 5 figures, submitted to Nucl. Instrum. and Meth.

    Tracking system based on GEM chambers

    Get PDF
    GEM chambers are becoming one of the best technology for charge particle tracking fulfilling the challenging requirements of modern experiment at intermediate and high energy, including Parity Violation Electron Scattering experiments. GEM tracker combines high spatial resolution, large active area and pretty good tolerance to high particle flux, at reasonable cost. GEM technology is shortly presented and a specific application for the high luminosity experiments in Hall A at JLab is discussed. Some alternatives to the GEM are also addressed

    Test of the CLAS12 RICH large scale prototype in the direct proximity focusing configuration

    Get PDF
    A large area ring-imaging Cherenkov detector has been designed to provide clean hadron identification capability in the momentum range from 3 GeV/c up to 8 GeV/c for the CLAS12 experiments at the upgraded 12 GeV continuous electron beam accelerator facility of Jefferson Laboratory. The adopted solution foresees a novel hybrid optics design based on aerogel radiator, composite mirrors and high-packed and high-segmented photon detectors. Cherenkov light will either be imaged directly (forward tracks) or after two mirror reflections (large angle tracks). We report here the results of the tests of a large scale prototype of the RICH detector performed with the hadron beam of the CERN T9 experimental hall for the direct detection configuration. The tests demonstrated that the proposed design provides the required pion-to-kaon rejection factor of 1:500 in the whole momentum range.Comment: 15 pages, 23 figures, to appear on EPJ

    Embedded software developments in KM3NeT phase I

    Get PDF
    TheKM3NeT collaboration has already produced more than one thousand acquisition boards, used for building two deep-sea neutrino detectors at the bottom of the Mediterranean Sea, with the aim of instrumenting a volume of several cubic kilometers with light sensors to detect the Cherenkov radiation produced in neutrino interactions. The so-called digital optical modules, house the PMTs and the acquisition and control electronics of the module, the central logic board, which includes a Xilinx FPGA and embedded soft processor. The present work presents the architecture and functionalities of the software embedded in the soft processor of the central logic board

    Measurement of the atmospheric muon depth intensity relation with the NEMO Phase-2 tower

    Get PDF
    The results of the analysis of the data collected with the NEMO Phase-2 tower, deployed at 3500 m depth about 80 km off-shore Capo Passero (Italy), are presented. Cherenkov photons detected with the photomultipliers tubes were used to reconstruct the tracks of atmospheric muons. Their zenith-angle distribution was measured and the results compared with Monte Carlo simulations. An evaluation of the systematic effects due to uncertainties on environmental and detector parameters is also included. The associated depth intensity relation was evaluated and compared with previous measurements and theoretical predictions. With the present analysis, the muon depth intensity relation has been measured up to 13 km of water equivalent.Comment: submitted to Astroparticle Physic
    • …
    corecore